Categories: Hookup Guide-PIC

How to burn code using Serial Programmer

There are many ICSP compatible serial programmers available for PIC Microcontroller. Read more about serial Programmers.

For using serial programmers, OpenLab should be in programming mode.

  • Connect the 6 pin connector to the ICSP port of the board
  • Open PICPgm programmer software
  • Click on Autodetect Programmer button
  • Programmer status will be shown on status bar. Most of the Serial programmers are JDM programmers.
  • Next click on Autodetect PIC, the Autodetect PIC dropdown menu will show the Microcontroller family.
  • Next, you can browse and select the hex code and then program it.

Share